General resistance rtd-100 manual

 · Product Attributes: brand=general resistance, inventory location=sd19, sku=, mpn=rtd RESISTANCE RTD Description Da Rtd General Resistance Rtd. Important disclaimer: you are buying lab supplies which can be used in chemical and laboratory processes potentially dangerous. If you have any questions, please email us. (RTD) or direct resistance-initiated analog input data from the module. Included is: · a general description of hardware features · an overview of module and system operation · compatibility General Description The IR6 module supports RTD and direct resistance signal measurement applications that require up to six channels. 6 SLC ™ RTD/Resistance Input Module Publication INC-EN-P - December Required Tools and Equipment Have the following tools and equipment ready •small blade screwdriver ( inch slot width) •RTD module (NR8) •RTD sensor or resistance input •appropriate cable (if needed) •programming equipment RTD / resistance INPUT.

RTD output (Table 2/3) Sk1 = Edit Sk2 = Settings Options (If applicable) Description RTD or Ohms An input measurement task: RTD - Measure RTD temperature OR Ohms - Measure RTD resistance. RTD or Ohms An output task: RTD - Simulate RTD temperature OR mA DPI only. A mA measurement task. mA(24V) DPI only. A mA measurement task + the loop. RTD (Ω) = to °F ( to °C) = 32 to °F (0 to °C) Limit Mode 1 = High limit with manual reset on power loss 2 = Low limit with manual reset on power loss 3 = High limit with automatic reset on power loss 4 = Low limit with automatic reset on power loss. NOTE: Electromechanical relays are warranted for , Buy General Resistance RTDX RTDx, RTD Simulator, % Accuracy and more from our comprehensive selection of General Resistance RTD Simulators.

The RTD is designed for use as control input for freeze protection and temperature maintenance applications requiring pipewall or tankwall temperature sensing. INPUT: Platinum RTD, ohm (-RBPx) - ohm (Ro) Platinum Resistance Temperature Sensor (RTD), 2, 3, or 4 wire connection. Standard calibration is based on the international R versus T curve having an alpha of ohms/ohm/oC (Pt). The unit can also be calibrated for sensors having an alpha of ohms/ohm/oC (Pt). RTD Assembly with plug and jack connector Hygiene Assembly Special Bearing Type RTD Assembly Mineral Insulated RTDs Individual black sleev Black sleev Ø 4mm(nominal) ss braided Ø 6mm, ss Pot Seal White rubber Bush Black rubber Bush Spring RTD: 4 Wire Duplex OD: Min MM L 20 www.doorway.ru www.doorway.ru